Assembled dendritic titanium catalysts for enantioselective hetero-Diels-Alder reaction of aldehydes with Danishefsky's diene

A new type of dendritic 2-amino-2'-hydroxy-1,1'-binaphthyl (NOBIN)-derived Schiff-base ligands have been synthesized and applied to the titanium-catalyzed hetero-Diels-Alder reaction of Danishefsky's diene with aldehydes. These reactions afforded the corresponding 2-substituted 2,3-dihydro-4H-pyran-4-ones in quantitative yields and with excellent enantioselectivities (up to 97.2 % ee). The disposition of the dendritic wedges and the dendron size in the ligands were found to have significant impact on the enantioselectivity of the reaction. The recovered dendritic catalyst could be reused without further addition of the Ti source or a carboxylic acid additive for at least three cycles, retaining similar activity and enantioselectivity. The high stability of this type of assembled dendritic titanium catalyst may be attributed to the stabilization effect of large-sized dendron units in the catalyst molecule. The other important phenomenon observed with this catalyst system is that a higher degree of asymmetric amplification has been achieved by attachment of the dendron unit to the chiral ligand, which represents a new advantage of dendrimer catalysts for asymmetric reactions using chiral ligands of lower optical purity.     

聚甲醛自然老化的SEM研究

对户外曝晒3～36个月的聚甲醛(POM)老化形态进行了研究,讨论了老化层厚度,裂纹宽度、裂纹深度及断口形态与老化时间的关系。结果表明:POM的老化导致了材料内部结构由韧性变成脆性而几乎完全丧失物理机械性能。     

PREPARATION OF POLYSULFONAMIDE/TiO2 NANOCOMPOSITES BY SOL-GEL

Polysulfonamide (PSA) was synthesized at room temperature, the polymerization based on terephthaloyl chloride and 3,3 '-diaminodiphenylsulfone in the common solvent N,N -Dimethyl-acetamide (DMAc). Polysulfonamide/titanium oxide nanocomposites were prepared by sol-gel method. Tetrabutyl titanate(TBT) was added into the polysulfonamide solution, at the same time ,some water was mixed to make the TBT hydrolyze. In the process, hydrochloric acid was used to catalyze the reaction. The polysulfonamide chemistry structure was characterized by FT-IR spectrum. Atomic force microscopy (AFM) was employed to observe the microstructure of the composite film. The thermal property was investigated by TGA.The results show that we have succeeded to synthesize the polysulfonamide, TiO2particles were well distributed in the composite film and average size was about 20 nm on average, the heat-resistance of nanocomposite was batter than the pure polysulfonamide.     

Investigation of Tomato Plant Defence Response to Tobacco Mosaic Virus by Determination of Methyl Salicylate with SPME-Capillary GC-MS

Headspace SPME was applied to investigation of tomato plant defence response to tobacco mosaic virus (TMV) by determination of compounds emitted from tomato plants at the extraction conditions of 25 °C and 15 min. It was found that TMV-inoculated tomato plant released large amount of methyl salicylate (MeSA) as response to TMV and MeSA concentration changed dramatically with time after inoculation. Gaseous MeSA as a signaling compound could induce in surrounding tomato plants to produce salicylic acid (SA) and synthesize and release MeSA. These results show that MeSA might be an airborne plant-signalling molecule in tomato plant response to TMV. The present method provided low detection limit of 2.0 ng L^–1 and needed little sample preparation time (15 min), so the method makes it easy to find the critical times of tomato plant response to TMV by fast determination of MeSA released from tomato plant.     

Method development for the quantitation of ABT-578 in rabbit artery tissue by 96-well liquid-liquid extraction and liquid chromatography/tandem mass spectrometric detection

Quantitative determination of drug concentrations in tissue samples can provide critical information for drug metabolism, kinetics, and toxicity evaluations. For analysis of tissue samples using liquid chromatography/tandem mass spectrometric (LC/MS/MS) detection, homogenization is a critical step in achieving good assay performance. Assay performance can be closely evaluated by spiking the drug directly into tissue samples prior to homogenization. It is especially important to include this assay evaluation for the analysis of artery tissue samples because artery tissue is very elastic, making it quite a challenge to develop an effective procedure for homogenization. An LC/MS/MS assay in 96-well format using liquid-liquid extraction was developed for analyzing ABT-578 in rabbit artery samples. Tissue quality control samples were prepared by spiking ABT-578 stock solutions directly into the tissue before homogenization. The usage of the tissue control samples gives a thorough evaluation of the sample preparation process that includes both homogenization and sample extraction. A 20% blood in saline solution was used as a homogenization solution. Calibration standards were made by spiking ABT-578 into rabbit whole blood. Blood quality control samples were also prepared by spiking ABT-578 into rabbit whole blood. These blood QC samples were used to confirm the validity of the calibration curve. A lower limit of quantitation of 0.050 ng/mL was achieved. The linear dynamic range of blood standards was from 0.050-30.3 ng/mL with the correlation coefficient (r) ranging from 0.9969-0.9996. Overall %CV was between 1.3 and 7.0%, and analytical recovery was between 98.2 and 105.8% for blood QC samples. The %CVs for tissue QC samples were between 6.7 and 13.0%, and analytical recovery after correction was between 93.5 and 114.3%.     

配合物Cu_2（C_（21）H_（20）N_2O_3）（CH_3COO）_2的EXAFS研究

用延伸Ｘ射线吸收精细结构（ＥＸＡＦＳ），测定了标题化合物中两个铜原子的配位结构。两个铜原子有相同的配位，确认每个铜原子均与一个氮原子，三个氧原子形成四配位结构。一氧一氮源于ＨＳＢ，而另两个氧由乙酸提供。     

Structural Features of a Polysaccharide from Centella asiatica

Centella asiatica has been used as remedy for sodation, stabilization and against lepra, anabrosis1 in the oriental countries. The low-molecular-weight constituents in Centella asiatica have been investigated1. However, no polysaccharides have been reported. 1BI was the first polysaccharide isolated from C. asiatica, which had immunostimulating activity in vitro. In present study, we report the structural features of 1BI. Experimental Extraction, isolation and purification Dried C.…     

Surface chemistry studies of (CdSe)ZnS quantum dots at the air-water interface

Trioctylphosphine oxide- (TOPO-) capped (CdSe)ZnS quantum dots (QDs) were prepared through a stepwise synthesis. The surface chemistry behavior of the QDs at the air-water interface was carefully examined by various physical measurements. The surface pressure-area isotherm of the Langmuir film of the QDs gave an average diameter of 4.4 nm, which matched very well with the value determined by transmission electron microscopy (TEM) measurements if the thickness of the TOPO cap was counted. The stability of the Langmuir film of the QDs was tested by two different methods, compression/decompression cycling and kinetic measurements, both of which indicated that TOPO-capped (CdSe)ZnS QDs can form stable Langmuir films at the air-water interface. Epifluorescence microscopy revealed the two-dimensional aggregation of the QDs in Langmuir films during the early stage of the compression process. However, at high surface pressures, the Langmuir film of QDs was more homogeneous and was capable of being deposited on a hydrophobic quartz slide by the Langmuir-Blodgett (LB) film technique. Photoluminescence (PL) spectroscopy was utilized to characterize the LB films. The PL intensity of the LB film of QDs at the first emission maximum was found to increase linearly with increasing number of layers deposited onto the hydrophobic quartz slide, which implied a homogeneous deposition of the Langmuir film of QDs at surface pressures greater than 20 mN.m(-1).     

CHIP-mediated hyperubiquitylation of tau promotes its self-assembly into the insoluble tau filaments

The tau protein is a highly soluble and natively unfolded protein. Under pathological conditions, tau undergoes multiple post-translational modifications (PTMs) and conformational changes to form insoluble filaments, which are the proteinaceous signatures of tauopathies. To dissect the crosstalk among tau PTMs during the aggregation process, we phosphorylated and ubiquitylated recombinant tau in vitro using GSK3β and CHIP, respectively. The resulting phospho–ub-tau contained conventional polyubiquitin chains with lysine 48 linkages, sufficient for proteasomal degradation, whereas unphosphorylated ub-tau species retained only one–three ubiquitin moieties. Mass-spectrometric analysis of in vitro reconstituted phospho–ub-tau revealed seven additional ubiquitylation sites, some of which are known to stabilize tau protofilament stacking in the human brain with tauopathy. When the ubiquitylation reaction was prolonged, phospho–ub-tau transformed into insoluble hyperubiquitylated tau species featuring fibrillar morphology and in vitro seeding activity. We developed a small-molecule inhibitor of CHIP through biophysical screening; this effectively suppressed tau ubiquitylation in vitro and delayed its aggregation in cultured cells including primary cultured neurons. Our biochemical findings point to a “multiple-hit model,” where sequential events of tau phosphorylation and hyperubiquitylation function as a key driver of the fibrillization process, thus indicating that targeting tau ubiquitylation may be an effective strategy to alleviate the course of tauopathies.

Multiple-hit model for tau aggregation, where sequential events of tau phosphorylation and hyperubiquitylation function as a key driver of the fibrillization process.